AnsweredAssumed Answered

Running STM32F4 Discovery board on 1.8 Volt

Question asked by Mostafa B on Mar 3, 2018
Latest reply on Mar 4, 2018 by Mostafa B

I need to run the board on 1.8 v.

I found this thread about the changes need to be made to the board. However, it is not clear to me how to:

  1. Program the board when on 1.8 v, using JLink v8. Do I need to perform any hardware modification or can I connect the programmer using SWD pins directly to the board.
  2. Use UART

Has anybody had any experience with running STM32F4 microcontrollers  on 1.8 v?

Outcomes