I need to select CAN 2.0 controller in my application.I would like to get low cost evaluation board for the same.
Please suggest me STM32 CAN2.0 board so that I can learn CAN.
Hello Akshay Bhavsar ,
I recommend you to use the "MCU Finder" tool , it will help you to find the STM32 microcontrollers which may answer your request.
I dont have to select controller.Controller that i select may not have evaluation board.rather i would select evaluation board having CAN,I2C,SPI interfcace
You don't have to use the LCD unless you need too. The STM32F429I-DISCO is probably a poor choice for other reasons, including the lack of pins in escape other interfaces. The Nucleo-144 boards offer more opportunity to add your own circuitry and interfaces.
ST's EVAL series boards provide CAN interface(s)
This board using the F107 provides for two STM32 ARM Cortex-M3 STM32F107VCT6 Development Board | eBay
as does the RedDragon407 STM32F4(Cortex-M4)+3.2 Ethernet(wireless) 2.4G SDIO Serial,camera | eBay
Does cortex m3 board has debugger on board?
Both cited boards have a 20-pin JTAG connector, you'll need to use an external pod, either a stand-alone ST-LINK, or pin wiring to one onboard a DISCO or NUCLEO board.
please send me link for ST link debugger
Could you try Google?
ST-LINK/V2 - ST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 - STMicroelectronics
i would prefer to get Nucleo-144 as having debugger on board.I have gone through them.Almost 20 types of nucleo-144 board are available.I need Ethernet connector,USB,I2C,SPI,CAN.I have selected NUCLEO-F446ZE.But datasheet says ethernet connector is available depensing on STM32 support.What does that mean?
>>What does that mean?
That some STM32 parts DON'T support Ethernet.. The F446 does NOT have Ethernet
For the NUCLEO-144 w/Ethernet
Retrieving data ...