when I use code generation, I see the ADC block is disconnected!
stm32 MAT/TARGET 4.4.2
Could you please give me more information?
- which STM32 you use?
- If you provide a little test case if possible or at least an ioc file and Simulink file.
I reinstalled the software and STM32 respond when I tried to provide a little test case!
I think it was my mistake, sorry for wasting your time.
thank you for your respond.
Is it works now? If you found cause of problem please describe how you resolved because it will helpful for of future readers with the same problem.
Yes it works now. I don't know the exact cause of problem but when I reinstalled stm32 MAT/TARGET and upgrade MATLAB from 2016b to 2017b problem solved!
Thank you so much.
Your well come.
thank you for your responds.
Retrieving data ...