AnsweredAssumed Answered


Question asked by vasilenko.sergey on Jan 16, 2018
Latest reply on Jan 19, 2018 by vasilenko.sergey

In the datasheet say that this pin must be work(indicate moment of magnetometer new data avalaible ) automatically(without need of configuration), but it doesn't work. Why?
In the said that M_XYZ_DA status bit must be connected with DRDY_M output pin(page 32, CFG_REG_C (62h) 0 bit).
Does not LSM9DS1 datasheet contain complete information?
This question(What does the DEN_A/G pin on the LSM9DS1 actually do? ) has proved this  assumption