Hi please help me with programming nucleo stm32f103 board with external stlink v2 programmer
What, exactly, is the problem ?
The following website host a lot of documentations: NUCLEO-F103RB - STM32 Nucleo-64 development board with STM32F103RB MCU, supports Arduino and ST morpho connectivity - ST…
Have you tried UM1727, the "Getting started" manual ?
Thanks for the reply, actually I just want to program my custom board with stm32f103c8 chip using stlink v2 programmer but i'am repeatedly getting the error message " target not found " what will be the possible causes for the above.
"Target not found" means the ST-Link works, but the programming/debugging tool cannot connect to the target.
What tool you talk about ?
Settings are correct (ST-Link, SWD) ?
Checked the voltages at the target supply (VDD) according to the schematics ?
Some jumpers pulled that need to be set ?
Before I forget it - had it worked before, i.e. could you have blown it ?
Retrieving data ...