Hello! I try to use a TIM1 in a PWM bipolar mode (chip is stm32f030f4p6).I use CubeMX . But after compilation of the project the timer doesn`t work. Must I write my own code for start this timer? Thanks a lot for your answer!
Read out relevant GPIO and TIM registers and check if their content is as expected, or if in doubts, post here.
Note that advanced timers needb TIMx_BDTR.MOE to have set.
Thanks for help! I added two functions: HAL_TIM_PWM_Start and HAL_TIMEx_PWMN_Start then complementary outputs worked.
Retrieving data ...