AnsweredAssumed Answered

STEVAL-BLUEMIC-1 can not connect via ST-Link

Question asked by Adriana Albert on Nov 6, 2017
Latest reply on Nov 9, 2017 by Adriana Albert



I am trying to test SPBTLE-1 with this evaluation board. I am using an STM32 Nucleo board as external ST-Link with the setup specified in user manual (DocID030830) linked below and BlueNRG-1 ST-LINK Utility software.


When I connect the system via USB to my pc (usb dongle of the Nucleo board) I get the following reports:

  • FAIL.TXT: "The interface firmware FAILED to reset/halt the target MCU" 
  • DETAILS.TXT: "Version 0221"


When I try to use ST-Link utility I get "No target connected"


I have no problem for program the Nucleo board using STM32 ST-Link Utility.


Any advice?


User manual (setup at page 22):