AnsweredAssumed Answered

Stm32f103 MCO output

Question asked by paul sauv on Sep 10, 2017

I try to configure my MCO ouput on my STM32f103, only with STD periph lib.

here is my code:

    void OutputMCO() { GPIO_InitTypeDef GPIO_InitStructure;  RCC_APB2PeriphClockCmd(RCC_APB2Periph_GPIOA, ENABLE);  /* Output clock on MCO pin ---------------------------------------------*/  GPIO_InitStructure.GPIO_Pin = GPIO_Pin_8; GPIO_InitStructure.GPIO_Mode = GPIO_Mode_AF_PP; GPIO_InitStructure.GPIO_Speed = GPIO_Speed_50MHz; GPIO_Init(GPIOA, &GPIO_InitStructure);  // pick one of the clocks to spew //RCC_MCOConfig(RCC_MCOSource_SYSCLK); // Put on MCO pin the: System clock selected //RCC_MCOConfig(RCC_MCOSource_HSE); // Put on MCO pin the: freq. of external crystal //RCC_MCOConfig(RCC_MCOSource_PLLCLK_Div2); // Put on MCO pin the: System clock selected }

I have an issue here:

// pick one of the clocks to spew //RCC_MCOConfig(RCC_MCOSource_SYSCLK); // Put on MCO pin the: System clock selected //RCC_MCOConfig(RCC_MCOSource_HSE); // Put on MCO pin the: freq. of external crystal //RCC_MCOConfig(RCC_MCOSource_PLLCLK_Div2); // Put on MCO pin the: System clock selected

None of the 3 possibilities are working on my code. This code was found on internet. Do you know where should I find correct parameters ? The definition of RCC_MCOSource doesn't really help me

Thank you

Outcomes