AnsweredAssumed Answered

SPC58ECx wakeup from standby using WKUP Pin

Question asked by R PV on Sep 2, 2017
Latest reply on Sep 15, 2017 by R PV

hello team,when i wakeup from standby mode always system reset was generating.My SW not jumping to address what i mentioned in CADDR register .when i debug the issue found "F_FCCU_HARD" Flag was enable after wakeup. is there is any method to disable this Flag permanently? if yes.please share some sample code to handle FCCU Module?

Thanks in advance.

Outcomes