Does stm32f429zi support usb in hs mode? i found that PB 14 is required by USB-HS but on that pin red led is connected.
Thanks for support.
Hi John Doe,
Since you need this pin for USB HS transfers, please follow the steps below:
1. Configure the PB13 as "Reset State".
2. Configure the External Phy depending on your needs (OTG/Dual_Role_Device, Host_Only, Device_Only).
You will notice that the CubeMX tool has configured all the pins needed by the ULPI interface.
Thank you Khouloud G !
You are welcome
If you have further questions, do not hesitate to post them in our forum.
Retrieving data ...