AnsweredAssumed Answered

using UART

Question asked by di_mascio.stefano on Nov 27, 2015
Latest reply on Dec 1, 2015 by di_mascio.stefano
Hello everybody,

I'm using the SPC56EL70L5DISP board.

In order to use UART, I put the jumpers in J18 and J20 to connect UART-MCU LIN0, following the board user guide.

Running the test example with UART and blinking LEDs, I try to read the hello world from a PC. I use a serial to USB adapter and a software configured for 38400-N-1 with no flow control or handshaking. I don't receive anything though.

I'm asking for a confirmation: should this work or did I miss something here?

Thanks in advance for the help.