AnsweredAssumed Answered

BOOT0 direct connection to GND?

Question asked by rocca.stephane on Nov 29, 2015
Latest reply on Nov 29, 2015 by rocca.stephane
Hi all,

I just received my new layout based on STM32F2 and I can't upload via SWD (Vlink V2).
Always the same mistake : Can't reset the core...

I checked VCAP1 & 2 at 1.2V and all SWD lines.
But perhaps I made a mistake : in older layouts, BOOT0 was pulled down by a 10K resistor, but in this new version, BOOT0 is direct to GND.

Is it a problem?

Thanks in advance ;)

Outcomes