AnsweredAssumed Answered

STM32F4 Disco Connect Under Reset

Question asked by ghanmy.montassar on Jul 20, 2015
Latest reply on Jul 20, 2015 by ghanmy.montassar
Hi there , I had my STM32F407VG discovery board for a while now, till a few minutes earlier, I was trying to interface a button to PA13 ( I chose PA13 randomaly) to create a simple interaface for my project , but once I tired the button few times I did not work, What's even worse now my Discovery board is not detected by CooCox and on the ST Link Utility it says "Cannot Connect to target , please Connect under Reset" (which works).
How Can it revert it back to how it was ? Did I mess up anything ? Does PA13 have to do with anything of this ??

Thank you !!!

Outcomes