Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Apr 23, 2007
on Apr 23, 2007 by 18716
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Apr 23, 2007 9:43 AM
I am writing a driver for spi controllet to read SPIEEPROM M25PE80
I have programmed the spmode ad 0771 , which means the loop back is off.
But still it is operating in the loop back mode.
The pin configuration is correct as per my knowledge.
Any kind of help would be appreciated.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32F769I-DISCO: No audio output from wm8994
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.
Efficiently use DMA with UART RX on STM32