AnsweredAssumed Answered

STM32F4 UART programming

Question asked by leon42 on Jul 30, 2013
Latest reply on Mar 3, 2014 by Clive One
I have managed to make Flash loader demonstrator work with my FTDI.

 Whenever I want to connect to my STM32F4 Discovery board I have to do that in two steps. Firstly I connect proper pins from FTDI to PCB, then I open Flash loader demonstrator, chose my options and click next. Then I get this warning screen: No response from the target.

If i close this screen and then again click next I come to flash status page. This is really annoys me, becouse I get this window and I have to make a couple more clicks. Is there any solution to this problem, becouse if I want to programm 50 boards, that would take a lot more time.

Outcomes