AnsweredAssumed Answered

ST-Link problems on STM32F103

Question asked by van_wyk.herman on Feb 5, 2013
Latest reply on Feb 8, 2013 by Clive One
Hi all,

I am having difficulty using an ST-Link V2 to program the FLASH of my STM32F103 on the STM3210E-EVAL board. It programs up until the last block and then states a message that programming to that location failed. If I connect my J-Link to program all works fine.

I have seen suggestions with regard to firmware upgrades and software upgrades, but none of the upgrades made any difference on my system.

Can anyone tell me what might be wrong?

Thanks,

H

Outcomes