AnsweredAssumed Answered

How to use the UART on the STM8A-DISCOVERY?

Question asked by Philipp Krause on Dec 25, 2015
Latest reply on Jan 11, 2016 by Philipp Krause
I want to use the UART on the STM8A-DISCOVERY boards.
However, AFAIK, the STM8A RX and TX pins are not connected to any header on the boards.
There are open solder bridges connecting them to the ST-Link/v2 interface. I could just solder some wires to the STM8 side of these open solder bridges to get the RX/TX signals. Any better ideas?

Philipp

Outcomes