AnsweredAssumed Answered

STM32 Discovery Embedded Serial bootloader USART

Question asked by singh.ishmeet on May 14, 2012
Latest reply on May 14, 2012 by singh.ishmeet

I want to boot my stm32 discovery board (STM32L152RBT6) using usart. I have tried going into system memory boot mode by putting BOOT0=HIGH and BOOT1=LOW. Then i tried to send my .BIN file using hyperterminal (Nothing happens). I also tried Flash loader utility by ST(It hangs on detecting the target).

I also read some data sheets about In Application Programming. I downloaded the IAP firmware, and burnt it, but nothing appears on hyperterminal maybe because usart might have some different configurations set on it.

I just want to program my flash memory of stm32 discovery board using usart. Please help! After i boot into system memory ,whats next?

Outcomes