Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on May 3, 2006
on May 3, 2006 by 13323
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
May 3, 2006 6:58 AM
Hi to all,
is it possible to perform an interrupt on USB pheripheral by reading (PC side)?
In other words, I'm creating a firmware that use USB with a single EndPoint in reading (STR7 -> PC), then I modified usb_conf.h with below command line:
#define EP1_Callback EP1_isr //EP1_isr Interrupt Endpoint Routine
By PC side, nevertheless, when I perform a reading, the interrupt does not generated then EP1_isr does not executed!!!
I hope that is a my error, could you help me to found it or suggest another solution?
Thanks in advance to all
#define EP1_Callback EP1_isr
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32-C2C (Cellular to Cloud) Web Concierge Portal
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration