Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Jun 20, 2008
on Jun 20, 2008 by 3099
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Jun 20, 2008 3:18 AM
How to create, configure ,compile new application in Hitop ide?
It requires symbol file and I didn't find any clear doc help on creating symbol file in Hitop using its Symbol Preprocessor.
Also .elf file is to be given at start which we dont have.
So please tell me the complete procedure to use Hitop IDE, complete steps to configure,create, compile,debug new application.
Thanks for your Help
[ This message was edited by: sr_shinde on 20-06-2008 07:20 ]
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.