AnsweredAssumed Answered

SWD connector on custom board

Question asked by elgarbe on Apr 10, 2015
Latest reply on Apr 11, 2015 by Clive One
Hello, I have a STM32F411 nucleo board and I would like to cut STLink out. I'm building a shield for nuecleo board and I want to add a SWD connector. So I look at CN4 on STLink and  altium schematic and I have some doubt about pin 1. On DM00105823.pdf say VDD_TARGET, but I can't figure out how it work on STlink 2 altium schematic. It is connected to GND throug a 10K resistor and goes nowhere (becouse there is no R9 on the board). So does anybody have a conection example for this connector?

BR

Outcomes