AnsweredAssumed Answered

Discovery-WiFi and /ALRT signal

Question asked by Barta.Hank on Feb 10, 2015
The Murata manual describes the /ALRT signal that the Murata chip uses to indicate to the host that it has a message to send. Is this signal available on the Discovery-WiFi board? Can it be made available if not by default (and by default, I mean using the SPI firmware available from Murata.) 

The Murata SyChip SNIC monitor has the capability to assign the ALRT signal to values from 0-19 but I do not know how these map to pins on the Discovery-WiFi board.

Outcomes