AnsweredAssumed Answered

Flash programming STM3221G-EVAL

Question asked by oussama.dziri on Jun 13, 2014
Latest reply on Jun 14, 2014 by Clive One
Hi everyone,

I would like to flash programming my Stm3221G-Eval Boards without using The ST_link..

I already configure the boot mode {boot0,boot1} and the boards is properly connected to the PC via an RS232 cable  ...

when I start the flash loader demonstrator and I put the port's name I get this error "verify the boot configuration mode and the flash protection status"


also i want to know where can I get the binary file..

thanks.

Outcomes