AnsweredAssumed Answered

STM32F439_EVAL2 enable Touch Panel Interrupts

Question asked by aiyer.kartik on May 7, 2014
Latest reply on May 7, 2014 by Clive One
I'm working on the STM32F439 Evaluation board. The touch panel dirver in the demo code only polls for touch co-ordinates. I want to set it up so that I can get touch interrupts however when I look at the accompanying component driver, there stubs to enable interrupts on the TS3510 are all blank. Can someone who is familiar with this tell me how I might be able to enable touch interrupts. 

The TS3510 on the eval board is wired via I2C1. I found a Software guide for the TS351x series, but it does not mention I2C protocol (only SPI and SMBus). I've attached the document to the message.

Thanks
Kartik

Outcomes