AnsweredAssumed Answered

LSM6DS0 configuration issues

Question asked by thy on Jan 8, 2016
Latest reply on Jan 20, 2016 by thy
Hi, I am trying to communicate with an LSM6DS0 module via SPI. I can retrieve the WHO_AM_I register content succesfully, but then, when I try to set the CTRL_REG6_XL register to start the accellerometer then I am not able to do it properly. In particular, I write 0x20 and then read it again to doublechek, but the module replies 0xF0. And this happens whatever possible value I try to write into it: it always replies 0xF0. Clearly, when I further try to read the acc. register, no values are present.

It sounds like I am missing something. Any suggestion?

Thank you in advance and regards.

Outcomes