AnsweredAssumed Answered

[Solved] SPWF01SA switch from Data to Command mode

Question asked by kopaev.eugene on Mar 9, 2015
Latest reply on Mar 11, 2015 by kopaev.eugene
I'm configure my SPWF01SA.11 module as udp server:

Then send from PC some data. Module response me
+WIND:61:Incoming Socket Client:

+WIND:60:Now in Data Mode
<sended data>

How I can return module back to Command Mode?
I'm try send at+s. escape command via wifi, via terminal, in upper/low case - no effect.

Sorry! at+s. must be sending via UART without any delay between each char.