Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Dec 9, 2005
on Dec 9, 2005 by 17197
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Dec 9, 2005 12:42 AM
Hi flo 123
I recently started working on the ST7538 together with PIC18F252. I saw on the ST7 discussion group that you have implemented a communication routine for the devices. It would be great if you could send me a copy of that software.
And I am anable to write to the control register.
As the st7538 Datasheet specifies that data should be stable on raising of CLR/T signal.
I am writing my data bit to TxD pin on the falling edge of the CLR/T Signal.
And Iam tring to see CLR/T signal in the scope along with the TxD pin, after some 22bits I am anable to see CLR/T signal .
And after this I am anable to transmeet any thing to the power line.
It is working fine in default mode.
Plz help me to solve this problem, and It would be great if could send me a copy of control regester write routine of your program.
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration
Please provide a way to download older version of the cube.