AnsweredAssumed Answered

SPINFamily Evaluation Tool + STEVAL-PCC009V2 + EVAL6480H R1.1

Question asked by Phil on May 14, 2013
Latest reply on Jul 6, 2013 by Mote
Hello,

I want to get the SPINFamily Evaluation Tool (L6480) working but everytime I get an error message to make sure the communication board (STEVAL-PCC009V2) is connected to the PC and board firmware has been updated to the last version. The IBUUI Updater gets stuck at bulletpoint "Switch to DFU mode" (switching to DFU mode onboard does not affect).

I also purchased the ST-LINK/V2 and successfully flashed the firmware from the STEVAL-PCC009V2 page, but that does not affect neither.

I have seen exactly the same problem in other discussions but there has not been a useful solution yet.

I need support as soon a possible, my project is frozen now.

Kind Regards
Phil

Attachments

Outcomes