AnsweredAssumed Answered

eclipse tool chain setup (how to set debugger)

Question asked by Chan on Dec 2, 2015
Latest reply on Dec 4, 2015 by tarekb
Hi, I follwed this ST.com page for SW4STM4 install and then to Installing System Workbench for STM32 with installer page to install SW4STM4 tool.
I could import the Uart_printf project in the STM32cubeF4 package and build it. But I don't know how to program the board and run(debug) the program. Internet search lead me to this page below.
Tutorial: STM32 - Integrated Debugging in Eclipse using GNU toolchain
Then I found newest versions of gdb hardware debugging and open OCD is alread installed with the eclipse. Then I tried to configure for the debugger, but I don't know how to set it. Below is the capture. (port number 4242 is for ST-UTIL but I'm not sure it's for my case. I think I'm using ST-LINK/V2 on the board). And though eclipse said hardware gdb is already installed, I cannot find it in my C: drive. 
gdb.JPG
When I checked 'install new software' it shows me that GDB hardware debugging is already installed. In the image below, when I check Hide items already installed, the first item disappears meaning it's installed already.
Where is gdb installed? any help would be appreciated. 
best regards,
installed.JPG
Chan

Outcomes