Interface and Connectivity ICs
MEMS and Sensors
Analog and Audio
EMI Filtering and Signal Conditioning
Power Management and Motor Control
SPC5 Automotive MCUs
ST25 NFC/RFID Tags and Readers
Switches and Multiplexers
STM32 MCUs Community
MEMS and Sensors Community
Automotive MCUs Community
STM8 MCUs Community
Help the community
Share your activities
Contribute your knowledge
About this community
to create and rate content, and to follow, bookmark, and share content with other members.
Question asked by
on Nov 2, 2005
on Nov 2, 2005 by 16890
Show 0 Likes
No one else has this question
Mark as assumed answered
This content has been marked as final.
Show 1 comment
(Required, will not be published)
Nov 2, 2005 12:15 PM
I was trying to fire the SED 1565 LCD (on the SPI1) on the MB393 Board with a IAR compiler. Please find attached the project. I believe that the data is being transferred fine to the LCD. But the display doesn’t turn on.
I'm trying to see if anyone had any success in firing this LCD.
[ This message was edited by: iamanil on 02-11-2005 17:03 ]
[ This message was edited by: iamanil on 02-11-2005 17:07 ]
Show 0 Likes
Retrieving data ...
2018 STM32 Wish List
STM32-C2C (Cellular to Cloud) Web Concierge Portal
STM32F769I-DISCO: No audio output from wm8994
STM32CubeMX V4.24.0 code generation failure (bug report)
CubeMX SDIO DMA FatFS configuration