AnsweredAssumed Answered

Code Red / Red Probe with the 32F4 DISCOVERY board

Question asked by CS on Mar 26, 2013
Latest reply on Mar 28, 2013 by CS
Hi Folks 

I just thought that I would say that using the Code Red tools with the Discovery Board is quite simple:

Move the soldered links on SB3 and SB7 to SB2 an SB6.


Then all the debugger signals are available on the headers CN2 and CN3

 
CN3  1,2,3,4 = VCC, SWCLK, GND, SWO and CN2 5,6 = RESET and SWO. 

This is a quite a good low cost development system 

Outcomes