About Lyubomyr D

Lyubomyr D · 2018-09-17

Hello all.I would like to install the STM32CubeMX using Docker file for Ubuntu. How shall I do this?I know how to use the X-server, and GUI under docker with Ubuntu, however, when downloading the STM32Cube one has to register. I would like to automat...

Lyubomyr D · 2018-05-02

Posted on May 02, 2018 at 17:24HelloI run into a stupid problem. I have a data that is sent by a device with bitrate115200. I need to read it with STM2F4. The data is five HEX numbers.I was trying to do this in different ways but I failed. I am read...

Lyubomyr D · 2017-10-21

Posted on October 21, 2017 at 21:04Hello.I have some problem with LCD1602+pcf8574 (I2C) and STM32F0. I experience the following bugs1) When I try to display more than three symbols they seem to be ignored2) If I try to display three symbols, I have ...

Lyubomyr D · 2018-11-04

HelloI installed the Cube from command line. I did not notice ant proposals from installer. Perhaps, I have to do something special for Ubuntu 16.04 ?

Lyubomyr D · 2018-09-19

Thank You very much!

Lyubomyr D · 2018-05-07

Posted on May 07, 2018 at 19:12Thank You very much for Your time and hints.I found the problem. Apparently it was in two following linessprintf(uart2Data,'Waiting for data \r\n');HAL_UART_Transmit(&huart2, (uint8_t *)&uart2Data,strlen(uart2Data), 0x...

Lyubomyr D · 2018-05-03

Posted on May 03, 2018 at 07:48I am receiving not the data that I expect to receive. I see the correct data on the Logis Analyzer, but when I log to UART2 I see something different.

Lyubomyr D · 2018-05-03

Posted on May 03, 2018 at 07:46No, I am not using DMA. I tried but I was receiving only the first data value all the time.

User statistics

User Activity

How to install CubeMX with Docker

UART in STM32F407

LCD1602 + pcf8574 (I2C) + STM32F0

Re: How to install CubeMX with Docker

Re: How to install CubeMX with Docker

Re: UART in STM32F407

Re: UART in STM32F407

Re: UART in STM32F407