Custom board based on stm32mp151a. Migrating from kirkstone to mickledore and from SP_MIN to OPTEE. usart1 assigned for debuging, uart4 and uart7 for modbus communication.I cannot boot uboot with usart1 assigned as stdout-path. It boots with uart4 an...
Is there any documentation or guidance on how to configure Yocto to deploy a custom u-boot image? I've been following https://wiki.st.com/stm32mpu/wiki/How_to_configure_U-Boot_for_your_board and https://wiki.stmicroelectronics.cn/stm32mpu/wiki/STM32M...
Hi@Olivier GALLIENI have followed the steps in https://wiki.st.com/stm32mpu/wiki/How_to_create_your_own_machine#Generate_device_tree to generate a image for my specific machines dts. But when building the image the error below is generated. I have do...
ECO sources used (not git). Custom board based on STM32MP157AAA3.Both when using OPTEE in DDR and SRAM this issue occurs.The kernel reports an "cut here" and then reports:[ 0.273935] Unhandled fault: imprecise external abort (0x1c06) at 0x97638f7aThi...
Run bitbake rep and sync and DISTRO, then bitbake , it shows the EULA and the build start, interrupt the build by press CTRL-C, closing the console window and re-entering it. then start bitbake, below errors occur.Even creating a new folder running t...
The TF-A Makefile.sdk creates a small metadata.bin file for each type of boot (USB, SD-cARD, EMMC)1/ How to generates this outside of Makefile.sdk ? I use this, but is only generates one file and there seems no parameter for the type of the boot dev...
Today got an update message in SW4 Eclipse to update Did that. Now when trying to start "Debug" on an STM32MP1 board Exclipse just exits. The error is as follows. Debug files atttched.Getting frustrated with the AC6/STM32MP1/Eclipse solution as a ...
The Device Tree configuration link . https://wiki.st.com/stm32mpu/wiki/STM32_MPU_device_tree does not include scmi.dstiAfter a rough time lot to wade through trial an errors, we were able to reduce the SCMI errors. First we added #include "stm32mp15-...
For a custom board configured in CubeMX usingSTM32MP157AAA3 , UART4, 512MB DDR3L, (4Gx16) external crystal (HSE, LSE), and discrete power regulator, no PMIC, device trees were generated with CubeMXwhen compiling optree errors and warnings occur.[...
After compiling TF-A, uboot and optee, the flashing of the first mage xxx-usb.stm2 using the CLI tool ends with a wait for completion of the download this fails. The UART report a panic. Any idea how to look further. is this a problems with TF-A devi...