Hello all, I managed to enter the DFU mode by rebooting the SoC from the command line after setting the proper tamper register to get the Uboot to select my desired USB boot mode. After flashing the new image with the STM32CubeProgrammer I would li...
Follow the steps below:https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157x-DK2/Develop_on_Arm%C2%AE_Cortex%C2%AE-A7/Modify,_rebuild_and_reload_the_Linux%C2%AE_kernelMy system : Windows 10 + VMware +Ubuntu 18.04************...
I got my STM32MP157A-DK1 load STM32MP15-Ecosystem-v2.1.0/Starter-PackageUsing iPerf3 for UDP speed test, but only achieved around 345Mbps.Made sure the cable, labtop NIC, switch are compatible with Gigabit. Attching board eth0 configSettings for eth0...
Please refer to the release note for more information: STM32MP15 distribution for Android release note - v2.0.0
i ask if possible to install linux on my board stm32h745i-disco , if yes .... is there link or material to explain steps ?
I'm trying to use PA10 to drive a simple LED (custom board), but the I/O doesn't switch at all.PA10 is not used in any of the device trees. gpioinfo gpiochip0reports the I/O as "unused" and "output", but switching the I/O with gpioset gpiochip0 10=1d...
I'm working on project that is including ADC, timers and virtual UART. I'm working on STM32MP157C-DK2 board. So I started from example OpenAMP_FreeRTOS_echo from CubeMP1 software package v1.2.0. I'm using CubeIDE v1.4.0. When I reboot STM32MP1 and de...
I am working on developing firmware to run on the M4 coprocessor and I have been trying to do some basic testing using my own code and the OpenAMP_TTY_Echo example. I am debugging on an stm32mp157c-dk1 and I am using STM32CubeIDE. This issue is also ...
Hello,I'd like use several gpio buttons to onboard CN2 connector (STM gpios PF0, PF1, PF3, PF4, PF6, PF8). So I've add following string to stm32mp157c-dk2.dts filebuttonkeys { compatible = "gpio-keys"; left-key { label="Left key"; ...
I am following the link https://wiki.st.com/stm32mpu/wiki/Getting_started/STM32MP1_boards/STM32MP157x-DK2/Let%27s_start/Execute_basic_commandsi have connected the board to a LAN and the following result is obtained:Why don't i see the "inet xx.xx.xx....
