Hi,I have a STM32MP157F-DK2 when I try to install something with apt-get I get this error:root@stm32mp1:~# apt install python3Reading package lists... DoneBuilding dependency tree... DoneE: Unable to locate package python3The date is correct.If inste...
Hi,I work on a custom board using a DHCOR SoM with a STM32MP157C SoC. I setup the TF-A + OP-TEE boot chain for the secure boot and I managed to boot on the linux stm32 (v6.1). The board hangs at reboot :[ 1480.467975] reboot: Restarting systemI/TC: F...
Hello,I am trying to perform a bitbake build using micledore openstlinux weston on my STM32MP1 platform. During the final stages of the build, I am encountering an error related to wireplumber that stops the process.Here are the details of the error:...
i used stm32cubeMX to generate code to support GPIO external interrupts.i expected to use HAL_GPIO_EXTI_Callback and it compiled but did not work.i had to use HAL_GPIO_EXTI_Falling_Callback and HAL_GPIO_EXTI_Rising_Callbacki used a Nucleo-U5a5ZJ boar...
HiI plan to interface the MT9M001 CMOS sensor (Parallel Interface) with STM32MP135F-DK, but the development board comes with the MIPI CSI2 Interface. Please guide me as to the process of integration and using OpenCv. Thanks
Dear,I'm starting with OP-TEE on STM32MP15x line. I bring-up the board as described here and built the optee_example_hello_world as described here. However, I got the error code below:TEEC_Opensession failed with code 0xffff0008 origin 0x3Checking th...
hi,I'm currently designing a custom board using the STM32MP157F MPU, and I'm referencing the schematic of the STM32MP157F-DK2 evaluation board. I'm stuck on identifying a specific component with a 0603 footprint. Is it a 0-ohm resistor? Additionally,...
please explain the steps on how to boot the image in sd card for stm32mp157d-dk1 and also which os should i need to use for programming
Hello Community, we're trying to debug an STM32 image (kernel-version V6.1.28) on the M4 core using STLINK-V3SET debugger via STM32CubeIDE (V1.16.0) and getting the following error: Error in final launch sequence: Failed pre launch (s. attached scree...
Hello, We are evaluating the X-STM32MP-GNSS1 eval board on STM32MP-157F-DK2.The X-STM32MP-GNSS1 has Teseo-LIV3F GPS receiver on it, which does not support NAVIC.Since we want to test receiving signals from NAVIC specifically, can we replace the Teseo...