Hello, I'm driving LED driver chip (MAX16836ASA+) with PWM output of microprocessor STM32F303CB.
The issue: When turn the Power supply ON, LEDs blinked for a few moments (milliseconds).
I assume that the PWM giving some output values (not zero) before the microprocessor is fully set and start operating.
Is there any options How to set PWM that default state is Zero (between Power Supply ON and microcontroller normally operating state)?
Thank you a lot,
Most of the STM32 pins are high-impedance (Input or Analog, in case of 'F3 Input) after reset. You have to ensure externally the required level, i.e. if the LED driver's input has pullup and you want the signal to be low, you have to add an external pulldown.