could not disable out protection
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2013-07-21 6:43 AM
Posted on July 21, 2013 at 15:43
hello every one.i have stm32f407 demo board that i cant program it any more. last program work correctly ,but if i want to erase the chip or program it again make the error
stilinkv2/and st-link software error ''could not disable out protection'' ulink and keil ''flash timeout .reset target and try again '' stlink/v2 and keil ''flash timeout .reset target and try again ''
This discussion is locked. Please start a new topic to ask your question.
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2016-04-02 6:19 AM
Posted on April 02, 2016 at 15:19
You'd need to replace all the parts destroyed by the application of the 10V to the circuit.
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..

- « Previous
-
- 1
- 2
- Next »