Hi ST USB PD community. I'm using https://github.com/STMicroelectronics/x-cube-tcpp but can't seem to find the right callbacks to respond to our port-partner when they send a Get_Battery_Status command.I need the ST MCU to respond with the Battery_St...
Hello, I'm using the Evaluation board B-U585I-IOT02A for the STM32U585, and I'm playing around with the USB communication using the example "Ux_Device_HID_CDC_ACM". However, I'm not sure to fully understand the use of the middleware USBPD, which in m...
Alright, so I've been struggling quite a bit for the past week trying to get the X-CUBE-USB-AUDIO project working in STM32CUBEIDE on a STM32H745 MCU and looks like I have more or less everything up and running pretty good, at least in 16 bit mode. Pr...
Hi ST, we are looking for solutions to supply > 100W over the new USB-C PD 3.1 spec, but due to the (very) short time since the release it seems that no one has updated its specs yet.So I would like to know how and when is ST going to officially supp...
Dear ST experts: I am a beginner with ST RTOS. I need your help. We have a project using FW in AMICAM1\UltrasoundFFT based on NUCLEO-STM32L476RG . There two threads in the FW. one is AMICAM1_Thread and another is AMICAM1_Thread. The Ultrasound FFT FW...
I'm bringing up a PD source and it will successfully negotiate an explicit contract, but if the source is unplugged and plugged back in, it will still negotiate correctly, but the PE will request a hard reset causing one to be sent 256 ms after PS_RD...
Hi, I'm doing a project which sends CAN data from B-G431B-ESC1 board to sth else(NI cRio).Just to make sure, do I have to set CAN TERM Pin(PC14) high by setting it GPIO_OUTPUT GPIO output level : High or is it high by default?I don't understan...
Hi team; We have selected Trust zone MCU STM32U585ZIT6Q (U5 series) for our project.We are using with Trust zone enable in our project.we have a query regarding the X-CUBE-CLASSB-U5.We have taken library of X-CUBE-CLASSB-U5 and test example code in S...
Hi,i have a question regarding the functional safety manual /safety mechanisms for the STM32F4 (and others with a similar functional safety manuals/mechanisms).A lot of SMs address transient, random faults, e.g. (refering to document UM1840):- CPU_SM...
I've worked out how to disable in the MEMs microphone I just want to use the blue 3.5mm input to receive/record the incoming audio. Thanks.