Ask questions and find answers on STM32Cube packages, including HAL, LL and middleware, and expansion software.
Dear STM32 Community, We believe that the example projects provided for the STM32Cube embedded software are a valuable resource when developing projects. We would like to better understand how developers use these examples in their workflow and e...
Hi ST Support Team,I am working with the STM32L476RCT6 on a custom-designed board for an NFC reader project.I am facing a critical issue during basic bring-up:Issue DescriptionThe MCU appears to hang when using HAL_Delay() and HAL_UART functionsThe c...
Hi everyone,I’m relatively new to embedded systems, so apologies if this has already been discussed elsewhere. I’ve tried searching, but haven’t been able to find a clear solution.I’m currently developing a system based on the STM32F746G Discovery bo...
The board I am using is NUCLEO-H7S3 and I have encountered the following issuesI want to perform continuous and large data sampling using ADC+DMA, but when the collected value reaches 10000, the subsequent values become 0. When I modify the number of...
"I am currently working on implementing Ethernet communication using a NUCLEO-H753 board. As a first step, I attempted to perform a ping test. I followed the official tutorial videos provided by STMicroelectronics step-by-step, but unfortunately, I a...
Hi all, I’m debugging a reproducible SPI6 slave issue on STM32H753ZI and would like feedback from anyone familiar with H7 SPI v2 behaviour. Setup MCU: STM32H753ZIPeripheral: SPI6 slaveMaster: Raspberry Pi 5 (spidev)Pins: PA5 SCKPG8 NSSPG12 MISOPG14 M...
Hi, I am using the Nucleo-L552ZE-Q board. I use STM32CubeMX version 6.17.0 which appears to be the laters version. When generating code for SD card FAT FS using CubeMX i get "sd_disckio.c" file containing only stubs of the functions, without content ...
Added "DHCP" in the title to give the context. Using an STM32H7S78-DK I try to set up the network to join an IPv4 network through DHCP. I did set up the board using CubeMX, standard configuration, MPU activated. FreeRTOS + LwIP Removed all other inte...
Hi @Community, I have previously posted the same issue , that i have been working on the STM32H723ZGT6 - Nucelo board on Ethernet LWIP to acheive TCP/IP without free RTOS, Im still facing the same issue that i cant ping the IP.I have tried the GITHU...
I am using CUBEMX Version 6.10 STMCUBE IDE 1.16.0FW version F7V1.17.0Enabled LWIP ETH With FREERTOS CMSIS2same settings did with cmsis version 1 it's working but with cmsis version2 NOT WorkingI...
Hello,I am writing this because I am unable to enable the SAI on this development board. The strange thing is that I actually managed to enable it before and it was working correctly. However, while implementing another feature, I switched branches a...
