I'm working on a project that involves NFC communications, so I bought the two product listed in the title to start prototyping. The first step in my plan was to get some sample code running, so I downloaded the X-CUBE-NFC5 package. However, it's un...
I've been using the M24LR-Discovery kit to evaluate the read range to our 15693 tags. My measurements are in the 2.6 inch to 3.5 inch range, depending on how I set the Data Rate and subcarrier settings. The best range is achieved with 'LOW' date ra...
Hello everybody,I am trying to drive ST25T3911B with STM32F072RB. I am using X-NUCLEO-NFC05A1 mounted on the NUCLEO-F072RB.I have configured NUCLEO-F072RB with STM32CUBEMX, you can find the project file attached; for my application I have added CAN c...
Hello,I am using the ST25R3913, following the application note and matching tool to define LC components for EMC filter and matching circuit. Now the function test is quite good, but I have a high pulse at 3rd harmonics (40.8MHz), do you have similar...
We have some legacy TI tags in our ecosystem - (TI RI-I02-112A-03). The M24LR will read them. Our TI reader will READ and WRITE to them, but the M24LR will not WRITE to them. We see a '0000 (03) Option is not supported' message in the ISO15693 UI ...
Hello everyone. Is there any offical and stable library for CR95HF?I haved tried to use X-NUCLEO-NFC03A1 package but no success. Below my schematic and i think it same as X-NUCLEO-NFC03A1.I can not get it work. Cant read dev id.Cant get work init fun...
When I'm trying to send a ManageGPO RF command to activate GPO on a particular tag, the GPO is being triggered on any tag or on all tags within the reach of the reader (I use CR95HF for develompent), despite the fact I set UID and an address flag as...
I didn't find the topic about "Secure MCUs", so I posted the question here that relative to NFC.In the Secure NFC (https://www.st.com/en/secure-mcus/secure-nfc.html) section, there is a video on the bottom of the page, named "NFC secure mobile point ...
Hello.Attempt to debug the example code using 'J-LINK' in 'ST25RU3993-EVAL'.'J-LINK' has been connected to the entire line and no shock has occurred.But when I try to put the code on the board, it doesn't work normally and it's called "Could not conn...
