Find out more about STM32 implementations with external components, discuss use cases, and discover how to use new tools and ST components.
Hello,I have the TI ADS8350 and want to read both channels in parallel. They support SPI, but I can not figure out how to setup the dual SPI for this. Another way would be to use DMA, could someone point me in the right direction. I am using SMT32F41...
Hello,I am trying to connect an ILI9325C display to an STM32F401RET6 microcontroller Yes this is related to my previous post. After writing the code correctly and connecting the display, it doesn't respond and only has the backlight on (from the powe...
Hello.I would like to test communication with the following configuration.But I don't know how to achieve this purpose.PurposeSend and receive data between a PC and NUCLEO-L552ZE-Q via an 10BASE-T1L cable.Devices to useNUCLEO-L552ZE-QEVAL-ADIN1110EBZ...
Hi,I'm facing an I2C communication issue between an STM32F107RCT6 microcontroller and the MAX11612EUA ADC. I created a clean project in STM32CubeMX using HAL library v1.1.9.0. I'm using HAL_I2C_Master_Receive_IT() to read data, and in the callback I ...
Hi, I'm trying to implement BACnet using an STM32F401RE Nucleo board and a W5500 Ethernet shield, but I'm having trouble adding the BACnet source files. I'm unsure exactly which source and header files I need to include. Despite several attempts, I...
Hello,I am trying to connect an ILI9325C display to an STM32F401RET6 microcontroller. After writing the code correctly and connecting the display, it doesn't respond and only has the backlight on (from the power supply). I connected the STM32 to a lo...
Posted on June 29, 2017 at 21:08Hello Guys , I am writing a programme in STM32F302R8 and trying to interface c8855m OEM Print Cartridge Driver through SPI protocol. I have to transmit 8 bit data in DCLK of Controller but it transmit 16 bit. Could...
I am using a STM32L031F6P6 device, with a microchip port expander: MCP23S17, off the SPI bus. I am using the device in interrupt mode, so when a gpio changes state, it sets its int line, which is tied back to my stm part. In my int handler, al...
Hi, I'm using a STM32L031K6 with platform.io & arduino framework. I know this forum is not relevant to platform.io or arduino, but most of my code is with LL drivers which should change nothing (but maybe ?). First, i don't understand the IRQn. I'm u...
I want to load 320 megabytes of data into flash memory quickly.I want to write a code in stm32cubeide.for example, can a code block be created by defining a buffer and using crc?can anything be done using the stm32 processor?
