Is there anybody who have a copy of that old ('80) sound generator, marked by SGS, used in some old italian keyboards like the GEM ones? I have references only for the M114A, but that is bigger (48 pin against 40 pins) and seems to be a bigger versio...
For the safety analysis of our battery management system design we need a pin FMEA for the M95640-DRMN3TP/K. Is there such information available?
I have recently purchased an X-STM32MP-GNSS2 Evaluation board. I want to collect IMU and GNSS raw measurements using Raspberry Pi 3 B+.It would be a great help if you could provide me with some online resources or examples files. Thanks.
I am using M24C08(1K), M24C16(2K) and M24C32(4K) along with this I am planning to use the M24C64(8K) eeprom.How can we differentiate the 4K and 8K eeprom using software. I have implemented a logic to read last page of the eeprom. Let's say I am havin...
I would like to inquire about the thermal resistance (θJA) of this specific part. Could you kindly provide the θJA value or direct me to the relevant technical documentation?M95128-DFCS6TP
Hi everyone,Looking at the Datasheet (DS) of the temperature sensor LMx35, I found that the equation on page 6 is wrong, in the sense that the subindex and '=' symbol are missplaced, and there is no reference of what does each symbol means.https://w...
Thank you for your help.The data sheet for Eas (single pulse avalanche energy) of VNLD5160-E states that it is 37mJ at Tj=150℃, but please tell me the Eas at Tj=25℃.If it has not been measured, how many times would it be calculated?Thank you in advan...
Hi,I am new to the EEPROM and embedded.I am having M24M02-DWMN3TP/k EEPROM in my custom board with XCZU2CG Ultrascale Zynq MPSOC processor. This EEPROM is in i2c expander, here I am attaching schematic of EEPROM and i2c devices list on bus 0(I have e...
Hi ST Team,We're using the GPIO pin to turn on MOSFET for power supply. We've tested many PD apdater, almost all the single port adapters work properly with STUSB4500. But it doesn't work properly with Apple Dual Port Adapter, 35W A2676, If I set PDO...
M24M01 parts, other than the wafer option, are currently NRND. We have a design that uses an M24M02 and want to add two M24M01s on the same bus. Is there a pin compatible replacement for this part with the same configurable I2C address capability, or...