Hello, I am planning out a project that uses new BLE 5.4 feature periodic advertising with response and I wanted to use STM32WBA as a broadcaster and STM32WB0s as observers. There seems to be a g...
Hello, I am working on a new design using the STM32WBA52CGU6. Is it possible for me to use the MLPF-WB55-01E3 to match the antenna impedance? Or what is the output impedance of this MCU? T...
Hi, I am using stm32wba55cg nucleo board, and running the example application BLE_p2pServer. While the serial logs of the board show that the device is in advertisement mode, it can not be d...
I found the DMA request mapping of the F4 series on ST's official website. With this form, I can configure DMA on zephyr. My problem is that I cannot find the DMA request mapping of STM32WBA...
Hi Guys, I was planning to start a project using the STM32WB55 chipset to implement a device capable of connecting to both Zigbee and BLE devices via a dynamic concurrent mode approach. I was able t...
Hi community, I understand that users can encrypt and sign firmware using STM32CubeProgrammer. My question is about the first stage bootloader provided by ST. From my limited reading, it seemed ...
Hi all, I check with STM32WBA55 datasheet have description can supported external PA. But FW SDK(STM32Cube_FW_WBA_V1.4.0) released notes exist below description. It l...
Hi, i am working with BLE_p2pServer_ota example with NUCLEO-WBA55 board and i want to activate security communication. Can someone guide me? Is there a step by step application note available?
Hello, I am working with STM32WBA52 and I am using the X-Nucleo-NFC07A1 Tag to try to perform BLE OOB Pairing. From the sparse existent documentation regarding this subject, I have understood that t...