Programming,

[rthe.drummer9]

Posted on October 21, 2012 at 19:43

I have a problem with programming a Stm32f0Discovery board,

When i have a code built and the board connected with STM32 ST-LINK Utility, and i click program it says: No Stlink detected.

What am i doing wrong,

[Tesla DeLorean]

Posted on October 21, 2012 at 21:24

Make sure you have suitable drivers installed. Things like Keil come with an install directory for the ST-LINK.

Check if it is seen in device manager.

Check if you have settings to permit unsigned drivers.

Check if you have administrative rights.

[egenchic]

Posted on October 22, 2012 at 15:13

Hi clive1.

can you look at my post [date:22.10,2012] and give some advices about STM32f0 i2c (I am very new to STM32). I will appreciate it a lot.  - k.j.001

[Tesla DeLorean]

Posted on October 22, 2012 at 15:45

can you look at my post [date:22.10,2012] and give some advices about STM32f0 i2c (I am very new to STM32). I will appreciate it a lot.  - k.j.001

 

Please don't hijack threads.