The new STM32H7R/S lines are built on the success of the STM32H7 series, offering even higher performance and security at a lower cost. The STM32H7R/S is a bootflash-based MCU powered by a Cortex®-M7 core running up to 600 MHz, with 64 KB of user fla...
Sorry, I have another question to ask everyone. I'm currently using the Nucleo F429ZI with SPI interface to receive 12-bit encoded data from another ADC. The Vdrive of that ADC can provide 3.3V or 5V for driving. However, the high level of the STM32F...
Hi,Developing software on STM32 MCUs - in the case STM32F3discovery.I am using rust and reasonably (no expert) used to developing and running code using the environment but I am unsure how to run the code outside of the debugger.I build a release ver...
I'm developing a new project based on STM32G431RB using STM32CubeIDE 14.1.0 on macOSI'm having touble where the program will hang at the first call of HAL_Delay() and digging deeper it's hanging because HAL_GetTick always returns 0It looks like the S...
I am starting some test with this modulehttps://it.aliexpress.com/item/1005002482177244.htmlwith 7” lcdI have found only one example that run but with TouchgfxI have got the same ioc from this example to generate a new code and insert the functions t...
What is the procedure to flush Tx and Rx FIFOs when using SPI DMA in STM32H563ZI?
I'm having issues with using the SDK of ST25RU3993. Specifically, while reading tags, I seem to get too much of a latency.I have went through the header files, but don't seem to find the appropriate variable.Currently each RFID scan takes about 24 s...
hi,I initialized string array with strings and type cast to uint32_t to store in flash memory as uint32_t. And then read the array as uint32_t. I update one of the string of the array and type cast uint32_t to store that array in Flash memory back. ...
Hi I am new here. I am looking for a driver for Windows 11 Arm (parallels M1). The chip on my board says STM32F105. The driver that worked for me last time on other Windows was: dpinst_amd64 Can someone advise a driver for Windows 11 Arm (running Pa...
I have been developing a system using an SMT32L476 but it is only rated to 125C .I'm looking for a temperature range of 150C . Its is desing into a piece of test equipment that goes within a thermal Chamber and cna overshoot ot 130-50 before settlin...
