cancel
Showing results for 
Search instead for 
Did you mean: 

Do wakeup pins PA0, PC13 and PB3 on STM32WL55 require external pull-up?

MAmiri
Associate II

I cannot find the external requirement for wakeup pins PA0, PC13 and PB3 on STM32WL55.

Do they need a pullup (e.g. 10K) to keep the output state once the MCU goes into one of the sleep modes?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Hello

All GPIOs contain 40K PU/PD resistors. Some of them are maintained in Low pawer modes.

There are no special requirements for external pullups .

VILo , VIHi ,leakage current and other factors determine the max pullup/down resistors.

This is from DS

0693W000007DBKfQAO.jpg

View solution in original post

2 REPLIES 2

Hello

All GPIOs contain 40K PU/PD resistors. Some of them are maintained in Low pawer modes.

There are no special requirements for external pullups .

VILo , VIHi ,leakage current and other factors determine the max pullup/down resistors.

This is from DS

0693W000007DBKfQAO.jpg

MAmiri
Associate II

Thanks Vangelis Fortounas!