FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Cube ide 1.4 doesn't recognize nucleo 32 board on linux.

PRedd.111
Associate III

‎2020-12-21 06:25 PM

I have an STM32 Nucleo 32 (F303K8) and was able to use it before. But 1.4 doesn't seem to recognize the boards. I even connected STLink-v2 device and even that did not get identified.

0 Kudos
1 REPLY 1
Cartu38 OpenDev
Lead II

‎2020-12-21 11:14 PM

Starting STM32CubeIDE 1.4.0 ST-Link server driver is required. Have you installed it ?

Takes care if updating (Thnaks Help>Check for Update) from some release to 1.4.x such drivers are not managed. Only fresh install starting from installer is supporting such.

By the way consider 1.5.1 latest release if possible doing fresh install.

0 Kudos
Top