Where is the SPI configured in the uSD FatFS example for the F7 microcontrollers?

[JWood]

I've been sucessfully using the SD card example in the CubeF7 files, but I can't understand where the SPI connections are set up, and if I was to choose SDIO instead, where would I do that?

It seems to just magically know I've connected it to the SPIA port on the nucleo board, without any of the lengthy initialisation you normally see in the main.c file.

Thanks!

[Tesla DeLorean]

The NUCLEO / ADAFRUIT stuff is hidden in the BSP code

STM32Cube_FW_F7_V1.16.0\Drivers\BSP\STM32F7xx_Nucleo_144\stm32f7xx_nucleo_144.h

/*############################### SPI_A #######################################*/

#ifdef HAL_SPI_MODULE_ENABLED

#define NUCLEO_SPIx                   SPI1

#define NUCLEO_SPIx_CLK_ENABLE()            __HAL_RCC_SPI1_CLK_ENABLE()

#define NUCLEO_SPIx_SCK_AF               GPIO_AF5_SPI1

#define NUCLEO_SPIx_SCK_GPIO_PORT            GPIOA

#define NUCLEO_SPIx_SCK_PIN               GPIO_PIN_5

#define NUCLEO_SPIx_SCK_GPIO_CLK_ENABLE()        __HAL_RCC_GPIOA_CLK_ENABLE()

#define NUCLEO_SPIx_SCK_GPIO_CLK_DISABLE()       __HAL_RCC_GPIOA_CLK_DISABLE()

#define NUCLEO_SPIx_MISO_MOSI_AF            GPIO_AF5_SPI1

#define NUCLEO_SPIx_MISO_MOSI_GPIO_PORT         GPIOA

#define NUCLEO_SPIx_MISO_MOSI_GPIO_CLK_ENABLE()     __HAL_RCC_GPIOA_CLK_ENABLE()

#define NUCLEO_SPIx_MISO_MOSI_GPIO_CLK_DISABLE()    __HAL_RCC_GPIOA_CLK_DISABLE()

#define NUCLEO_SPIx_MISO_PIN              GPIO_PIN_6

#define NUCLEO_SPIx_MOSI_PIN              GPIO_PIN_7

...

/**

 * @brief SD Control Lines management

 */

#define SD_CS_LOW()    HAL_GPIO_WritePin(SD_CS_GPIO_PORT, SD_CS_PIN, GPIO_PIN_RESET)

#define SD_CS_HIGH()   HAL_GPIO_WritePin(SD_CS_GPIO_PORT, SD_CS_PIN, GPIO_PIN_SET)

...

/**

 * @brief SD Control Interface pins (shield D4)

 */

#define SD_CS_PIN                 GPIO_PIN_14

#define SD_CS_GPIO_PORT              GPIOF

#define SD_CS_GPIO_CLK_ENABLE()         __HAL_RCC_GPIOF_CLK_ENABLE()

#define SD_CS_GPIO_CLK_DISABLE()        __HAL_RCC_GPIOF_CLK_DISABLE()

Different example? Be specific..