Install X-CUBE-SUBG1 in STM32CUBEMX

[RGarc.1]

Hello!

I want to make a basic remote control with the SPSGRF-915 module, but as far as I can understand I need the X-CUBE-SUBG1 extensión software to control it.

I have already downloaded the software from ST (en.x-cube-subg1_firmware) and on the STMicroelectronics tab from the Embedded Software Package Manager in CubeMX, I can´t find the extensión package, so I tried to upload from the local .zip previusly downloaded but the following error appears:

The following file is not recognized as being valid ...

Thanks for your attention

[JRuiz.1]

Hi!

I'm trying to do the same and getting the same errors.

Did you get and answer or a solution?

[Laurent Co · Accepted solution]

Hello JRuiz,

Unfortunately, The X-CUBE-SUBG1 is not enhanced for STM32 toolset.

You could find the ones enhanced with the link below, looking at the corresponding column:

https://www.st.com/content/st_com/en/products/embedded-software/mcu-mpu-embedded-software/stm32-embedded-software/stm32cube-expansion-packages.html#products

Regards,

Laurent