Can't Debug in Engineering Mode using STM32MP157-DK2. OpenOCD Error: Could not find MEM-AP to control the core

BMcCa.3 · ‎2019-07-17

Trying to create a simple application that will toggle LD9 in Engineering Mode but get an error with the OpenOCD.

Output on console window is as follows:

Open On-Chip Debugger 0.10.0+dev-01124-gbfb41e6 (2018-11-16-15:23)

Licensed under GNU GPL v2

For bug reports, read

debug_level: 1

cortex_a interrupt mask on

cortex_a domain access control fixup on

3333

none separate

adapter speed: 5000 kHz

adapter_nsrst_assert_width: 200

adapter_nsrst_delay: 200

none srst_pulls_trst

srst_only srst_pulls_trst srst_gates_jtag srst_open_drain connect_deassert_srst

Error: Could not find MEM-AP to control the core

ap 0 selected, csw 0x10006000

Error: Target not examined yet

undefined debug reason 7 - target needs reset

Error: Target not examined yet

Error: Could not find MEM-AP to control the core

Error: Target not examined yet

embedded:startup.tcl:24: Error:

in procedure ‘stm32mp15x.cpu2’ called at file “embedded:startup.tcl�?, line 283

in procedure ‘ocd_bouncer’

at file “embedded:startup.tcl�?, line 24

Error: Target not examined yet

AntonioST · ‎2019-07-17

In Engineering mode, OpenOCD should be run setting the variable "ENG_MODE" to examine the Cortex-M.

This is already done by the IDE.

Running OpenOCD from the command line, use:

openocd -c 'set ENG_MODE 1' -f board/stm32mp15x_dk2.cfg

BMcCa.3 · ‎2019-07-17

Hi Antonio.

I am using the IDE using the default settings.

The Script File does inevitably load the …_dk2.cfg file.

I want to test using the command line. How do I do this? With the "Command Shell Console" using local settings?

BMcCa.3 · ‎2019-07-17

The image wasn't captured in the previous post